How to install Jiffy Ice Auger Propane Hose for Ice Drill Feldman part 4352

To install a Jiffy Ice Auger Propane Hose (part number 4352) on your ice drill, follow these steps:

1. Make sure that the propane tank is turned off and disconnected from the ice auger.
2. Locate the propane hose connection point on the ice auger. It is usually located near the engine.
3. Remove the cap from the propane hose connection point.
4. Take the propane hose and attach one end to the connection point on the ice auger.
5. Tighten the connection using a wrench, if necessary.
6. Take the other end of the propane hose and attach it to the propane tank.
7. Tighten the connection using a wrench, if necessary.
8. Turn on the propane tank and check for any leaks by applying a soapy water solution to the connections and looking for bubbles. If there are no bubbles, the connections are secure and there are no leaks.

If you are unsure about any of these steps or have any doubts about your ability to safely install the propane hose, we recommend seeking the help of a qualified mechanic or technician. It is important to follow all instructions and safety precautions carefully to avoid any accidents or injuries.